brass barb hose tube quick disconnect connector
author:MF manufacturerstime:2022-03-14 21:09:57
Abrasive conditioners are mainly used for providing abrasive sand in the process of water jet cutting,above the cutting head,Different cutting effects are formed by controlling the amount of sand。
(brass barb hose tube quick disconnect connector)Rear mounting plate removed from
Regulator。 Use the mounting plate to locate and
Drill mounting holes in the machine。
(brass barb hose tube quick disconnect connector)Notice:The holes on the mounting plate are
positioned at each center2inch(50.8mm)
other and counter boring.25(6.35mm)
flat head screw。
(brass barb hose tube quick disconnect connector)

2.Reassemble the rear mounting plate to
(brass barb hose tube quick disconnect connector)back mount(brass barb hose tube quick disconnect connector)Regulator。
board seeNote
(brass barb hose tube quick disconnect connector)3.Remove the bottom adapter from the adjuster
Pull the bar upwards,in order to have
The regulator can be mounted to the machine。 use
¼inch(6mm bolt)cap screws for mounting
(brass barb hose tube quick disconnect connector)Regulator。
4.Screw the lever back to its original position
Location。
accessories needed:
(brass barb hose tube quick disconnect connector)Require:60-80 psiEnter compressed air。
3/8“OD x 1/4”Polyurethane tube。
(brass barb hose tube quick disconnect connector)The outer diameter is1/4“of nylon or polyethylene tubing to connect the regulator cylinder to the solenoid valve
4Road spring return direction solenoid valve。 This requires pressure sanding/close abrasive
Cylinder in both directions。
1/4Tube
CONNECTIONS
1.Connect the four-way valve connection to2(two)
accessories on the cylinder。 When the solenoid valve is
Power off or grind switch in off position,
The regulator will close。
2.WillN / Ovalve connector(with air pressure)Connected to
assembly inside the cylinder see。

(brass barb hose tube quick disconnect connector)
3.open with abrasive/Turn off the grind switch
Acrylic tube of the regulator to verify the regulator
(brass barb hose tube quick disconnect connector)Valve works normally。
4.Will3/8The tube is connected to the outlet tube at the bottom
Regulator。
(brass barb hose tube quick disconnect connector)The hose from the tank to the metering regulator should have minimal elevation change。(brass barb hose tube quick disconnect connector)from the ground10'(foot)The maximum hose height of is usually sufficient。
Make sure the hose should not exceed the top of the metering regulator by more than two feet
dual flow。
The top of the regulator should be used90Degree connector。
Hose end connections should use brass barb fittings and hose clamps to prevent hose
from blowing off accessories。
If using multiple regulators
Use a hose from the pot to near the regulator。
divert,Enables multiple hoses to provide the same flow resistance。
(brass barb hose tube quick disconnect connector)Notice:When supplying multiple regulators from one tank,The path to each regulator must be
close to the same length,So each regulator will receive the same flow of abrasive。
Different hose lengths result in uneven wear pressure after splitting
(brass barb hose tube quick disconnect connector)Regulatory Authority。This can result in different abrasive flow rates between regulators。
The original text comes from the Speither Waterjet Parts Mall:
http://www.waterjetmall.com/cn/h-nd-41.html